Scroll Saw Fonts

I was recently contacted by a loyal reader who wondered if I might know where to find some good scroll saw fonts. The key is fonts that don't have holes in them. So that you understand this, let's look at the letter "O". Typically it has a hole in it. So if it were cut by a scroll saw, the middle would fall out. Thus a "scroll saw font" must have a way to connect all the holes. Of course you aren't limited to using them with a scroll saw.

That led me on a search where I found several fonts at Scrollcrafters. I'm not sure this will meet the needs of everyone, but at least a few choices are offered. For those of you who need this type of fonts, do you have any suggested fonts? Leave a comment and let us all know of other fonts that are available.